12 of Our Favorite Woodworking Tips and Tricks

Posted on

When it comes to woodworking, there’s no greater relationship than that of a carpenter and his (or her) saw. After all, a woodworker relies most on cutting machines to create works of art out of wood — even if it’s just a window frame. Woodworkers are always ready to try new ways of working faster and smarter in the shop. Great advice, tips and tricks on sawing are readily available, too. Below are 12 important ones to keep in mind during your next wood project.

1. To crosscut safely

Clamp a one-inch block of wood to the fence of your table saw before the blade, then make the cut length by setting the fence scale one-inch greater than the desired length. This way, the end of the board is free of the fence during and after the cut — and you can avoid getting a board kicked back directly at you.

2. Stair gauges

Are an inexpensive way to make your own crosscut guide for circular saws. Usually used to lay out stair jacks, stair gauges are available at hardware stores or home centers and can be clamped on the same tongue of a carpenter’s square and used as notch markers. Make sure to clamp the square in place so it won’t slide around while you’re cutting.

3. Use a drafting square

For measuring accurate 2- to 3-foot squares. Drywall squares can be inaccurate and carpenter squares can be especially cumbersome because they have to be hooked onto the edge of the work piece. Drafting squares are accurate, as well as, inexpensive and can be as useful as a tape measure in the shop.

Prev1 of 4Next

Leave a Reply

Your email address will not be published. Required fields are marked *